Direto w/ 11 speed Ultegra

Moderators: Elite Admin S, Elite Admin M

tacobrink
Posts: 1
Joined: Fri Jan 11, 2019 12:25 am

Re: Direto w/ 11 speed Ultegra

Postby tacobrink » Fri Jan 11, 2019 12:37 am

Yes I believe that I have the same problem . I have installed two brand new ultegra cassette and used two different bikes. Same results. When I shift past midpoint toward the smaller rings the chain begins to grind and skip. When I look back down at the cassette it looks almost like the sprockets are bent or crooked. Is it possible the hub of the direto is bent at the outer end? It is something I don't think we should need to accept? Any suggestion appreciated. Can I get a replacement hub?

djburton
Posts: 1
Joined: Thu May 02, 2019 3:00 pm

Re: Direto w/ 11 speed Ultegra

Postby djburton » Thu May 02, 2019 3:05 pm

I have the same issue also, was planning to take some video of it skipping to try to identify exactly how it occurs but I suspect flex / lack of security in the frame to QR skewer interface as one recent poster has suggested. However I don't think it's acceptable to write it off as some frames just not being a good fit for direct drive trainers. The trainer should be compatible with all typical road bike frames.

Anyone else made any progress with this issue?


Return to “Direto”

Who is online

Users browsing this forum: No registered users and 2 guests