Calibration value after screwing the tightener regulator lock screw

Moderators: Elite Admin S, Elite Admin M

isiora
Posts: 1
Joined: Fri Nov 30, 2018 9:14 am
Location: Salerno
Contact:

Calibration value after screwing the tightener regulator lock screw

Postby isiora » Fri Nov 30, 2018 10:21 am

Hi Elite,

I started the calibration procedure of my Direto because the offset dropped more than 5 points (6503 vs 6509, the value stamped on the sticker).
I had no problem to execute the procedure and to reach to original offset value again, until I screw the lock of the tightener regulator. After this action, the offset value dropped from 6509 to 6505. I repeated the procedure, but I had same result.
What I must do? Do I have I to make sure that the offset value is 6509 after screwing the lock, or no?

Thanks in advance.

User avatar
Elite Admin S
Posts: 1572
Joined: Tue Nov 08, 2016 10:18 am

Re: Calibration value after screwing the tightener regulator lock screw

Postby Elite Admin S » Mon Feb 04, 2019 2:46 pm

The value must be the same of the original one AFTER you close the lock

Regards

User avatar
Elite Admin S
Posts: 1572
Joined: Tue Nov 08, 2016 10:18 am

Re: Calibration value after screwing the tightener regulator lock screw

Postby Elite Admin S » Mon Feb 04, 2019 2:46 pm

The value must be the same of the original one AFTER you close the lock

Regards

danga
Posts: 10
Joined: Thu Jan 24, 2019 11:50 pm

Re: Calibration value after screwing the tightener regulator lock screw

Postby danga » Wed Feb 06, 2019 5:46 pm

Elite Admin S wrote:The value must be the same of the original one AFTER you close the lock

Regards

Support has advised it should be within 5 from the factory value? So which is it? Exact value or within 5 of the factory offset?

Thanks
David


Return to “Direto”

Who is online

Users browsing this forum: No registered users and 0 guests