Low power reading after spin down calibration

Moderators: Elite Admin S, Elite Admin M

kamolwatchara
Posts: 1
Joined: Sat Apr 25, 2020 4:09 am

Low power reading after spin down calibration

Postby kamolwatchara » Sat Apr 25, 2020 9:59 am

Hi
Bought my first smart trainer, a Suito a few weeks ago and did a spin down calibration for the first time this week.
The trainer prior to the calibration was reading around 5% higher than my crank power meter.
After the spin down, the trainer is now reading around 10% lower than the power meter.
I tried to do the spin down twice and tested after each, getting consistent result of ~-10% on both occasions.

Is there a specific way the spin down should be conducted? Do I need to stay clip in etc?

All else failing, is there a way to calibrate the trainer to reduce the difference between the power meter and the trainer?

User avatar
Elite Admin S
Posts: 1846
Joined: Tue Nov 08, 2016 10:18 am

Re: Low power reading after spin down calibration

Postby Elite Admin S » Thu May 21, 2020 8:47 am

Hi

Spindown with Suito must be done after a 10 minutes workout (no more, nor less) at around 20km/h (100-150W).
If you have done it properly, check to have calibrated properly also the power sensor.

If still you have a high difference, contact our customer care at myetraining@elite-it.com

Regards

msgcycle
Posts: 2
Joined: Mon Jun 08, 2020 7:20 pm

Re: Low power reading after spin down calibration

Postby msgcycle » Mon Jun 08, 2020 7:27 pm

Where do you do the spindown calibration?
I can't seem to find out how to do it anywhere.



Return to “Suito”

Who is online

Users browsing this forum: No registered users and 1 guest