Real Turbo Muin B+ configure PA and PB
Posted: Sun Sep 10, 2017 1:28 pm
Hi,
Does any one know how to configure PA and PB in a "Real Turbo Muin B+"?
I Followed the guide on the Elite Home Page that state you can configure these values in Real software under “Settings” – “Resistance Unit Calibration”. Only in version 7.2.0.77 you can only set one value between 0,5 and 1,5 ... not PA and PB. I am confused????
So I tried to connect to me trainer with the myETraning app via Bluetooth, and can get to the Advanced Settings where the PA and PB values are located - only when I change them and store the the app fools me to believe it will store the values, but if I read them back again, they were not changed???
Any ideas are welcome - it is a bit frustrating to see between 4-600 watt on the display during an easy warmup
Does any one know how to configure PA and PB in a "Real Turbo Muin B+"?
I Followed the guide on the Elite Home Page that state you can configure these values in Real software under “Settings” – “Resistance Unit Calibration”. Only in version 7.2.0.77 you can only set one value between 0,5 and 1,5 ... not PA and PB. I am confused????
So I tried to connect to me trainer with the myETraning app via Bluetooth, and can get to the Advanced Settings where the PA and PB values are located - only when I change them and store the the app fools me to believe it will store the values, but if I read them back again, they were not changed???
Any ideas are welcome - it is a bit frustrating to see between 4-600 watt on the display during an easy warmup