Real Turbo Muin B+ configure PA and PB

RealAxiom, RealTour, RealPower, Real Turbo Muin, Real emotion

Moderators: Elite Admin S, Elite Admin M

Posts: 1
Joined: Sun Sep 10, 2017 1:18 pm

Real Turbo Muin B+ configure PA and PB

Postby lap3520 » Sun Sep 10, 2017 1:28 pm

Does any one know how to configure PA and PB in a "Real Turbo Muin B+"?

I Followed the guide on the Elite Home Page that state you can configure these values in Real software under “Settings” – “Resistance Unit Calibration”. Only in version you can only set one value between 0,5 and 1,5 ... not PA and PB. I am confused????

So I tried to connect to me trainer with the myETraning app via Bluetooth, and can get to the Advanced Settings where the PA and PB values are located - only when I change them and store the the app fools me to believe it will store the values, but if I read them back again, they were not changed???

Any ideas are welcome - it is a bit frustrating to see between 4-600 watt on the display during an easy warmup

User avatar
Elite Admin S
Posts: 1574
Joined: Tue Nov 08, 2016 10:18 am

Re: Real Turbo Muin B+ configure PA and PB

Postby Elite Admin S » Mon Sep 11, 2017 9:33 am


The two values of Pa and Pb can be found on a label on the trainer.
When you change them in the app, the app will send those values to the trainer.
When you reopen the app, the values shown in the menu are the default values, not the latest values you've inserted.

So, please check your Pa and Pb values, insert them in the app and try again using the app/software.
If you still have wrong power values, please contact our customer care at explaining the situation


Return to “Real trainers”

Who is online

Users browsing this forum: No registered users and 1 guest