Rouvy FTP test - impossible resistance spike

Moderators: Elite Admin M, Elite Admin S

Mervster
Posts: 3
Joined: Tue Feb 05, 2019 10:32 pm

Rouvy FTP test - impossible resistance spike

Postby Mervster » Tue Feb 05, 2019 10:36 pm

Good evening all,

I have an elite Drivo and had been impressed until tonight when i attempted an FTP test through Rouvy. The test started off ok with power required around 125W, when the FTP kicked in it wanted sustained at 250 which was fine for about 10 mins until my trainer started to increase resistance to the point that i bombed out whilst knocking out 500+watts trying to turn the crank over. WTF is going on?

I then power cycled the unit and tried to run a seperate workout which had sustained effort followed by small spikes of high intensity. On the third spike, resistance increased to the point i couldnt turn the crank again?!?

Can someone help???

benjaray
Posts: 1
Joined: Tue Jan 03, 2023 9:14 am

Re: Rouvy FTP test - impossible resistance spike

Postby benjaray » Tue Jan 03, 2023 9:14 am

I have the same issue, did you ever resolve the problem?

mike.landmann
Posts: 14
Joined: Mon Oct 05, 2020 11:18 am

Re: Rouvy FTP test - impossible resistance spike

Postby mike.landmann » Mon Jan 09, 2023 2:52 pm

ERG mode is really only of use below your FTP. So I would recommend that you turn off ERG over 250w (or whatever your FTP is)


Return to “Drivo & Drivo II”

Who is online

Users browsing this forum: No registered users and 8 guests