Page 1 of 1

Turning Direto on / waking up - how?

Posted: Fri Dec 01, 2017 10:29 pm
by Boggles
Do I have to take the power connection out and put it back in each time I want to use it? Seems a bit clumsy.
It doesn't wake up by just pedalling.

Re: Turning Direto on / waking up - how?

Posted: Mon Dec 18, 2017 12:41 pm
by Elite Admin S
The Direto goes in stand-by mode after 15 minutes of no-speed data incoming.
It should wake up by pedaling on it, if it doesn't is really strange (is the speed sensor that "wakes up" the trainer, and if it normally works, it must work also to exit from the stand by mode). Please contact our customer care at real@elite-it.com to investigate further.

Regards

Re: Turning Direto on / waking up - how?

Posted: Wed Jan 24, 2018 10:16 pm
by Steve.t
Was this resolved as I have the same issue? When I want to calibrate the unit I have to unplug the unit for it to pick the trainer up even though It was connected seconds before to setup all the sensors in parameters.