Page 1 of 1

Elite Direto Firmware and Turn off

Posted: Fri Oct 20, 2017 11:13 pm
by jose84
Hello
I just recieved my new Direto and maybe I have two stupid questions:
1. No where in the documentation I found anything about something simple as Turn off, It says goes to "Sleep mode" but nothing else, is just a simple unplug from the electrical/enery wall plug?
2. How I can check that I have the latest version of firmware on my trainer?
Thanks
J.

Re: Elite Direto Firmware and Turn off

Posted: Tue Oct 24, 2017 11:34 am
by Elite Admin S
Hi

Direto doesn't have a switch to turn it off. You can decide if wait the stand-by mode or unplug it (best solution to avoid storm damages).
About the firmware, by now there is only one firmware for Direto so... you have the last one! ;)

By the way, in the future we will release an app that will check the firmware status of the trainer and eventually upgrade it.

Regards

Re: Elite Direto Firmware and Turn off

Posted: Tue Oct 24, 2017 2:01 pm
by jose84
Hello
Many thanks for the reply, actually I fond out that the Direto after a while of no use will shutdown itself. Also, thanks for the info about the firmware.
Now, I got another issue, I have my Garmin Edge 810 and I would like to pair manually the Direto since I got another Power meter next to it, where I can find this ID?
Thanks
J.

Re: Elite Direto Firmware and Turn off

Posted: Thu Oct 26, 2017 10:44 am
by Elite Admin S
Hi J.

Garmin Edge 810 doesn't support the fe-c trainers. You can connect to it only as a speed&cadence sensor + power sensor.
I don't know if this is the information you need.

Regards

Re: Elite Direto Firmware and Turn off

Posted: Thu Oct 26, 2017 10:50 am
by jose84
Hello
I found the ID for connecting manually to my Garmin 810, you need to take the cover of the leds and you'll dine the ID tag.
Thanks!