Official Forum

Hi Elite,

I started the calibration procedure of my Direto because the offset dropped more than 5 points (6503 vs 6509, the value stamped on the sticker).
I had no problem to execute the procedure and to reach to original offset value again, until I screw the lock of the tightener regulator. After this action, the offset value dropped from 6509 to 6505. I repeated the procedure, but I had same result.
What I must do? Do I have I to make sure that the offset value is 6509 after screwing the lock, or no?

Thanks in advance.

The value must be the same of the original one AFTER you close the lock

Regards

The value must be the same of the original one AFTER you close the lock

Regards

Elite Admin S wrote:The value must be the same of the original one AFTER you close the lock

Regards

Support has advised it should be within 5 from the factory value? So which is it? Exact value or within 5 of the factory offset?

Thanks
David