Turbo Muin and Misuro B+ power off by 340% watts
Posted: Tue Apr 07, 2020 12:15 pm
I have the Turbo Muin (S/N 1041X) and just purchased the Misuro B+ (S/N 190XX)
I have just now installed and positioned the Misuro B+ (as per Elite instructions) and configured it to 3 clicks (Turbo Muin has 1041X S/N)
I have done a couple of sessions with MyETrainer and FulGaz, and I only get around 80 watts (max 100 watts) and very slow speed, my experience is it should be around 250-300 watts for the effort I am doing.
I have googled to try to find a solution which led me to tighten the trainer belt to 2NM, but there was no improvement in the accuracy of the power reading).
I have also tried it on 12 clicks but this made no difference.
Any assistance or suggestions would be appreciated.
I would like to use with zwift, but with power readings so far off, it wouldn't work.
I have just now installed and positioned the Misuro B+ (as per Elite instructions) and configured it to 3 clicks (Turbo Muin has 1041X S/N)
I have done a couple of sessions with MyETrainer and FulGaz, and I only get around 80 watts (max 100 watts) and very slow speed, my experience is it should be around 250-300 watts for the effort I am doing.
I have googled to try to find a solution which led me to tighten the trainer belt to 2NM, but there was no improvement in the accuracy of the power reading).
I have also tried it on 12 clicks but this made no difference.
Any assistance or suggestions would be appreciated.
I would like to use with zwift, but with power readings so far off, it wouldn't work.