Official Forum

Hello,

I'm using Misuro B+ with Turbo Muin (S/N greatear than 18000). I have installed and configurated the sensor and the trainer and i can see data from power, speed, heart rate monitor (Polar H7), cadence (Polar Cadence sensor) in my mobile with My E.Trainning.

According to specifications Misuro B+ uses ANT+ and Bluetooth Smart protocols. The Misuro B+ uses ANT+ and Bluetooh Smart protocols that are compatible with many devices. I have it paired with my mobile with Bluetooth.

I also have a Polar v650 trainer. This trainer uses Bluetooth smart. But i can get it paired with the Misuro B+ sensor. I can see the Misuro sensor avalaible to pairing in my V650 but when i try to connect and link it it takes a long time trying and finally shows an error saying is not possible to pair.

The question is...is Misuro B+ really compatible with Polar V650? Or with any Polar trainer? I have search for a compatibily list but i was not able to find it.

Thanks in advance!

Are you sure that the misuro is not still connected to some other device? Bluetooth doesn't allow multiple connections.
Try in this way:
- remove the battery from the misuro
- power off all your devices (smartphone, tablet, Polar...)
- restart only your polar
- put again the battery on the misuro
- do again the coupling

Let me know if it works.

Hello,

Thanks for answering.

Finaly i could paired the misurob+ and my polar V650.

In the main screen appears as speed and cadence sensor found but according with i have read, misurob+ with my trainer does not sent cadence data. Since then, only speed data is sent to the computer.

Once i have start a new session the data of speed is shown in the session. The cadence is not shown (always is zero) but this is expected. I added screens to show power data but is always shown as zero.

Any suggestion?

I have my Garmin cadence sensor on the crank and I can use it on the Muin as well.
However, Garmin see Misuro B+ as one power sensor and one speed/cadence combo sensor.

So, if I will enable Garmin cadence - I will have two cadence sensors at the same time, not sure it works that way.
If I will disable Misuro sensor - I will lose speed reading, right?

antonio.delarosa wrote:Hello,

Thanks for answering.

Finaly i could paired the misurob+ and my polar V650.

In the main screen appears as speed and cadence sensor found but according with i have read, misurob+ with my trainer does not sent cadence data. Since then, only speed data is sent to the computer.

Once i have start a new session the data of speed is shown in the session. The cadence is not shown (always is zero) but this is expected. I added screens to show power data but is always shown as zero.

Any suggestion?

Could you connect your polarv650 with misuro b+ as a power sensor, I have the same issue.