My E-Training don't see ANT+ power sensor from Direto
Posted: Mon Dec 04, 2017 8:46 am
Hello,
Ive just purchased a brand new direto trainer.
I would like to do a calibration process and connect trining apps.
The problem is:
In the application e-training I can see the trainer direto itself [ANT+]
but cannot see additional power meter and cadence sensors throuhg the ANT+ protocol!
[In the part devoted to "Advanced Configuration" e-training app]
I tried on Android mobile. The Trinerroad APP sees the trainer correctly, comprehensively all the sensors after the ANT protocol!
I would like to do calibration procees to make sure my power trinings are well measured by direto!
What is wrong?? Plese help.
Ive just purchased a brand new direto trainer.
I would like to do a calibration process and connect trining apps.
The problem is:
In the application e-training I can see the trainer direto itself [ANT+]
but cannot see additional power meter and cadence sensors throuhg the ANT+ protocol!
[In the part devoted to "Advanced Configuration" e-training app]
I tried on Android mobile. The Trinerroad APP sees the trainer correctly, comprehensively all the sensors after the ANT protocol!
I would like to do calibration procees to make sure my power trinings are well measured by direto!
What is wrong?? Plese help.