Official Forum

Any chance to get Magene.cn Cadence sensor work properly ?
It connects and its sending dat to my training app if cadence higher than 30... but main problem is if you stop pedaling value no set to 0 but it stays at last displayed value (38 or 72 ... ecet)..
Is this sensor or app problem ?

Hi

Which transmission protocol does this sensor use? Is it ant+ or bluetooth smart?

Regards

Hi,

I have similar problem. I have a Garmin peddle sensor (ant+) that is detected during the parameter set up on my android phone. The myetraining app returns data during peddling from the misuro sensor on the turbo itself, it returns Hr data but it appears that the cadence data is not being picked up and it just shows 0.

Any suggestions?

Thanks

Rich

Are you sure that your phone supports the ant+ communication?
If not, you'll have to use a ant+ dongle

Regards