Elite Smart Novo - roller wear

Moderators: Elite Admin S, Elite Admin M

Posts: 1
Joined: Fri Mar 23, 2018 7:05 pm

Elite Smart Novo - roller wear

Postby Bhoy63 » Fri Mar 23, 2018 7:15 pm

I have just received a replacement turbo as my 3 month old one had a deep ridge worn in the roller.
I have set up the new one properly however I'm still a bit worried based on what happened to the previous one. The tyre is lightly touching the roller not tight on it.

After a quick spin a thin tyre line has marked the red roller , which I expect is normal

What wear would you normally expect to see on the roller over the next few weeks and months?


User avatar
Elite Admin S
Posts: 1506
Joined: Tue Nov 08, 2016 10:18 am

Re: Elite Smart Novo - roller wear

Postby Elite Admin S » Wed Mar 28, 2018 10:21 am


The problem is that the tire is not enough in contact with the roller (not the opposite!)
Please do the three complete turns of the knob, the tire must be well pressed on the roller. The roller will almost "enter" into the tire.
Verify also that the wheel is well inflated and remember to not brake during the training!


Posts: 1
Joined: Thu Dec 27, 2018 3:34 pm

Re: Elite Smart Novo - roller wear

Postby loicV » Thu Dec 27, 2018 3:41 pm

I have the same problem with my EVO. I used a special tire for home-trainer (Decathlon 700x25)
I tried for the first time this morning my new EVO and I observed this (attached picture). Is it normal?
Thank you
Picture of the roller
Photo.jpg (204.63 KiB) Viewed 85 times

Return to “Qubo Digital / Novo Smart”

Who is online

Users browsing this forum: No registered users and 1 guest