Page 1 of 1

Real Turbo Muin B+ configure PA and PB

Posted: Sun Sep 10, 2017 1:28 pm
by lap3520
Hi,
Does any one know how to configure PA and PB in a "Real Turbo Muin B+"?

I Followed the guide on the Elite Home Page that state you can configure these values in Real software under “Settings” – “Resistance Unit Calibration”. Only in version 7.2.0.77 you can only set one value between 0,5 and 1,5 ... not PA and PB. I am confused????

So I tried to connect to me trainer with the myETraning app via Bluetooth, and can get to the Advanced Settings where the PA and PB values are located - only when I change them and store the the app fools me to believe it will store the values, but if I read them back again, they were not changed???

Any ideas are welcome - it is a bit frustrating to see between 4-600 watt on the display during an easy warmup

Re: Real Turbo Muin B+ configure PA and PB

Posted: Mon Sep 11, 2017 9:33 am
by Elite Admin S
Hi

The two values of Pa and Pb can be found on a label on the trainer.
When you change them in the app, the app will send those values to the trainer.
When you reopen the app, the values shown in the menu are the default values, not the latest values you've inserted.

So, please check your Pa and Pb values, insert them in the app and try again using the app/software.
If you still have wrong power values, please contact our customer care at real@elite-it.com explaining the situation

Regards