direto training test

Choose your ideal trainer

Moderators: Elite Admin S, Elite Admin M

47stephen
Posts: 5
Joined: Mon Oct 09, 2017 11:00 am

direto training test

Postby 47stephen » Wed Oct 18, 2017 5:53 pm

hello there, i am trying to do a training test on my direto using the my e training app , whilst doing it the direto is beeping most of the time , is this normal ?

kdviner
Posts: 5
Joined: Wed Oct 18, 2017 8:03 pm

Re: direto training test

Postby kdviner » Wed Oct 18, 2017 11:12 pm

I have experienced that too. I am using ANT+.

User avatar
Elite Admin S
Posts: 416
Joined: Tue Nov 08, 2016 10:18 am

Re: direto training test

Postby Elite Admin S » Thu Oct 19, 2017 9:55 am

The beeping sound you hear is the internal stepping motor that is adjusting the trainer resistance, it's normal.
During the normal use of the trainer, the sound should be merely noticeable.

Regards

47stephen
Posts: 5
Joined: Mon Oct 09, 2017 11:00 am

Re: direto training test

Postby 47stephen » Thu Oct 19, 2017 10:36 am

thankyou , also i have noticed that the resistance on the training test is very hard to pedal , it says i am pushing out 100w where in reality it is much higher , if i increase the speed and cadence it still says 100w , is this right and is my trainer faulty in any way

User avatar
Elite Admin S
Posts: 416
Joined: Tue Nov 08, 2016 10:18 am

Re: direto training test

Postby Elite Admin S » Thu Oct 19, 2017 10:43 am

Have you done a calibration?
If not, do a 10 minutes warm up and then follow the calibration procedure.

47stephen
Posts: 5
Joined: Mon Oct 09, 2017 11:00 am

Re: direto training test

Postby 47stephen » Thu Oct 19, 2017 10:50 am

i have done a callibration test , it ran for about 20 seconds then said it was complete . I thought it would take longer to do than that so i tried again and the direto kept dropping the BLE signal when i started to pedal


Return to “Trainers general discussion”

Who is online

Users browsing this forum: No registered users and 1 guest