Search found 2775 matches
- Thu Jul 30, 2020 12:42 pm
- Forum: Smart Trainers
- Topic: Direto is Sliding when I apply force
- Replies: 1
- Views: 2538
Re: Direto is Sliding when I apply force
Hi Do a 10 minutes training and then run calibration (in my e-training). If the offset has decreased of more than 5 points compared to the original one, it may be necessary to tighten the belt. In this case, contact the customer care at myetraining@elite-it.com and explain the situation, they'll giv...
- Thu Jul 30, 2020 12:38 pm
- Forum: Smart Trainers
- Topic: Pairing Novo Smart, Power Sensor not connecting
- Replies: 1
- Views: 2808
Re: Pairing Novo Smart, Power Sensor not connecting
Hi
It's not clear: in my e-training power is properly shown?
It's not clear: in my e-training power is properly shown?
- Fri Jul 24, 2020 10:32 am
- Forum: Trainers general discussion
- Topic: Elite Suito adapters
- Replies: 2
- Views: 3441
- Fri Jul 24, 2020 10:30 am
- Forum: Drivo & Drivo II
- Topic: Drivo Erg Mode
- Replies: 172
- Views: 358454
Re: Drivo Erg Mode
Hi We have the possibility to increase speed of the Drivo. But as we already explained in other similar posts, the more you increase the speed, the more "harsh" will be the change of slope/power. This doesn't allow to adapt the pedaling to the new slope/power level. If you still think that...
- Fri Jul 24, 2020 10:12 am
- Forum: Interactive Trainers
- Topic: Elite Suito - Adjusting rear derailleur non resistance mode
- Replies: 14
- Views: 33208
Re: Elite Suito - Adjusting rear derailleur non resistance mode
Hi guys
There are a lot of different bikes with different derailleur.
So, every single case must be analyzed.
Please contact our customer care at myetraining@elite-it.com adding some photos, the guys there will give you instructions
Regards
There are a lot of different bikes with different derailleur.
So, every single case must be analyzed.
Please contact our customer care at myetraining@elite-it.com adding some photos, the guys there will give you instructions
Regards
- Thu Jul 23, 2020 12:09 pm
- Forum: Trainers general discussion
- Topic: My Etraining App
- Replies: 1
- Views: 3733
Re: My Etraining App
Hi
Kura is supported, you should see it.
Please check again, use the search button on the side of the lens
Regards
Kura is supported, you should see it.
Please check again, use the search button on the side of the lens
Regards
- Thu Jul 23, 2020 8:30 am
- Forum: Direto, Direto X, Direto XR
- Topic: Trainer does not wake up, no resistance on flats (zwift)
- Replies: 1
- Views: 1994
Re: Trainer does not wake up, no resistance on flats (zwift)
Hi
There seems to be an electronic problem (the wake up issue).
Please contact the customer care at myetraining@elite-it.com, the guys there will analyze the situation and send you a replacement board if needed.
This may also be the cause of the other issues you're experiencing
Regards
There seems to be an electronic problem (the wake up issue).
Please contact the customer care at myetraining@elite-it.com, the guys there will analyze the situation and send you a replacement board if needed.
This may also be the cause of the other issues you're experiencing
Regards
- Mon Jul 20, 2020 12:47 pm
- Forum: Qubo Power Mag Smart B+ / Aleno
- Topic: Elite Qubo Digital Smart B+ Turbo Trainer Tension Issue
- Replies: 3
- Views: 13487
Re: Elite Qubo Digital Smart B+ Turbo Trainer Tension Issue
Hi Qubo Digital Smart B+ uses a sensorless cadence algorithm that calculates cadence basing on microvariations that appears on speed when you give a pedal stroke. This works well if the chain is well tensed but can be unprecise when it is not (for example, if you have high cadence at low power). So,...
- Mon Jul 20, 2020 12:41 pm
- Forum: Turno
- Topic: Configuration/calibration of the Misuro B+ for Turno
- Replies: 2
- Views: 30392
Re: Configuration/calibration of the Misuro B+ for Turno
Hi
You have to set 15 flashes on the misuro for Turno.
Here's the instructions sheet:
https://drive.google.com/file/d/1sANzTE ... sp=sharing
Regards
You have to set 15 flashes on the misuro for Turno.
Here's the instructions sheet:
https://drive.google.com/file/d/1sANzTE ... sp=sharing
Regards
- Fri Jul 17, 2020 11:58 am
- Forum: Suito
- Topic: Change 11 gear cassette to 10 gear cassette
- Replies: 7
- Views: 6616
Re: Change 11 gear cassette to 10 gear cassette
Hi
Yes, you have to use one spacer. You can find it in the package (there are two of them in the adapter bag)
Regards
Yes, you have to use one spacer. You can find it in the package (there are two of them in the adapter bag)
Regards